Monday, 27 June 2016

C88 FLORAL DREAMS COLLECTION - BY TARYN JOHNSON

SHINE BRIGHT LITTLE DIAMOND



FOR THIS LAYOUT YOU WILL NEED:

Photos:  1 x 4 x 6” portrait – matt with Pink cardstock and gray cardstock, distress photo around the edges of all photos. Smaller photo 1 x 4”x 4” (10cm x 10cm), 1 x 5 x 7(13 x 18cm)

Paper: 2 x  (C 88 001) pattern sheet- background – pink dot side up, stick the MELODY 088 002 across the two pages, 3” (7.5cm) from the left and ½ inch from the top and bottom.
Cut a sheet of grey cardstock 8.5” x 6.5” and matt with pink cardstock.

Embellishments: Title chipboard (DC88 003), chipboard filigree (DC88 009) (DC88 010)(DC088 012) – Paint white and add gold or silver glitter, the wings you can add liquid pearls for colour 

Extras: White paper flowers , fussy cut FLUTTERSHINE C88 001 and MELODY C88 002 as shown on the photo, raise with 3D tape to create dimension.

Matting:  When matting add ¼” extra on each colour you matt with ie: photo size 4 x 6 (10 x 15 cm) – matting 4 ¼ x 6 ¼”(10.5 x15.5 cm) and so on.

Tip:   I always join my background paper at the middle so it’s easier to work across both of them.

Cutting instructions:

             Colour                                        Size

1.      Fluttershine C88 001    2 x sheets background
2.      Melody C 88 002           2 X sheets , 1 x fussy cutting , 1 x 11’ x 11.5 “(28cm x 28.5cm)
3.      Grey cardstock              ¼ matting on the pink
4.      Pink cardstock               ¼ matting on the photos


Right page:
        
             Colour                                        Size

1.      Cut after page is done

Instructions:

Left / Right pages

1.      Use FLUTTERSHINE C88 001 as the background
2.      Stick down the MELODY C88 002 and overlay the fussy cutting on top of the fairy and flowers.
3.      Stick down the grey on pink cardstock at an angle and add the 5” x 7” photo matt on top.
4.      Paint all chipboard white and add glitter.
5.      All the fussy cut pieces must be raised with 3D tape.
6.      Raise flowers on 3D foam to add dimension.
7.      Add dimensional glaze on the frame ,fairy wings, butterflies.
8.      Use the DS056 stencil , I used embossing paste – the large and small on the left and another small one on the right top corner.
9.      Cut the DC088 012 , keeping only the two ends and slip under the paper on the left.

My layout would be idea for a frame as a special gift to hang on your wall.
                                              

SCRAPWITHT.blogspot.com
IG scrapwitht





Post a Comment